10018-SR+

High strength, low alloy electrode designed to meet NACE MR0175 requirements of <1% Ni and max 22 HRc with stress-relief up to twelve hours.

Read More
14018

Ultra high strength, low alloy covered electrode for joining and repair of ASTM A148, A643, A787, and similar variations.

Read More
15018

Ultra high strength, low alloy electrode for use in joining and repair of ASTM A145, A643, HY130, LQ130 and similar variations where mechanical properties are comparable.

Read More
90T1-B9

High strength, low alloy FCAW wire for 9Cr-1Mo steels.

Read More
2553FC

Flux-cored, all position wire for duplex stainless steels containing approximately 25% Cr.

Read More
410MC

Modified 410-16 for adherence to NACE MR0175 after stress-relief.

Read More
410NiMo-16

Low carbon stainless coated electrode that meets NACE MR0175 requirements while still maintaining strength and toughness.

Read More
80T5-B6

Low alloy FCAW wire for 5Cr-0.5Mo steels.

Read More
8522N

SAW wire for welding quenched and tempered steels that will undergo PWHT.

Read More
BH13Cr

Metal-cored GTAW rod designed for manual TIG welding Super 13Cr steels.

Read More
Enduro5500

A metal-cored, hard banding wire that produces a wear-resistant, crack-free deposit on casing and tool joints.

Read More
SG-1

All position, flux-cored welding wire for use in joining AISI 4130 and similar steels.

Read More
YS75-S

A high strength, low alloy SAW wire recommended for joining AISI 4130, 8630, and variations thereof. This wire was specifically designed for welding Q&T steels that will undergo PWHT. Combined with appropriate flux will yield 100ksi UTS, 100 avg ft-lb at -20F, while still adhering to NACE MR0175

Read More
YS80-T

A metal-cored GTAW electrode designed to join and repair AISI 4130 steel and similar steels without re-quench and temper, using only a stress-relief.

Read More
YS130-FC

Ultra high strength, low alloy FCAW wire for use in joining and repair for ASTM A148, A757, HY130, LQ130, and similar steels.

Read More
YS130-S

Ultra high strength, low alloy composite wire recommended for the joining and repair of HSLA steels with similar recorded strength levels.

Read More
YS140

Ultra high strength, low alloy flux-cored wire for joining and repair of HSLA steels with similar recorded strength levels. Product provides high tensile and yield, with average impact strength greater than 20 ft-lbs at -40F.

Read More
YS145T

Metal-cored cut length wire for manual TIG welding. HSLA for join and repair of AISI 4340 and similar forgings without re-quench and temper.

Read More